Aug 06, 2022 Leave a message

How To Adjust The Process Parameters Of The Wave Soldering Machine?

The wave soldering machine has many process parameters, and these parameters affect each other, which is quite complicated. For example, changing the preheating temperature and time will affect the soldering temperature. If the preheating temperature is low, the pcb will absorb more heat when it contacts the wave peak, which will reduce the soldering temperature. For example, adjusting the transmission speed will affect all Parameters related to temperature and time have an effect, so no matter which parameter is adjusted, it will have a different effect on the other parameters.

To adjust the process parameters of the wave soldering machine, the ideal temperature curve and process specification should be designed according to the principle of wave soldering. As with reflow soldering, the real-time temperature profile is also measured and then adjusted based on the results of the trial or first weld (piece).

When comprehensively adjusting the process parameters, the welding temperature and time must be guaranteed first. The temperature of the double-wave soldering lead wave soldering furnace is controlled at 245±5℃, and the lowest value of the solder joint temperature on the PCB board of the temperature measurement curve is 215℃; The low value is 235°C.

The basic adjustment and control requirements of wave soldering process parameters are as follows:

a. The tin immersion time is: wave 1 is controlled at 0.3~1 second, wave 2 is controlled at 2~3 seconds;

b. The transmission speed is: 0.7~1.5 m/min;

c. The inclination angle of the pinch is: 4~6 degrees;

d. Flux spray pressure: 2~3Psi;

e. Needle valve pressure: 2~4Psi;

f. In addition to the above standard range of parameter setting, if the customer has special requirements for their products, the process engineer shall specify the implementation in the product operation instruction according to their regulations.

The contact length between the solder joint and the wave peak can be measured by a high temperature resistant glass test board with a scale. Transfer speed is a factor that affects yield. Under the premise of ensuring the welding quality, the purpose of increasing the output as much as possible can be achieved by comprehensively adjusting the various process parameters reasonably.

If the customer or product has a single specification and requirement for the temperature curve parameters, the standard should be negotiated with the customer according to the actual performance of the company's wave soldering machine to meet the requirements of the customer and the product.


Send Inquiry

whatsapp

teams

E-mail

Inquiry