If the tin in the wave soldering furnace is used for a long time, there will be a lot of impurities that have a great impact on the quality of the wave soldering joints. Therefore, after the tin in the wave soldering furnace is used for a long time, it is necessary to clean the tin in the furnace. How often should the tin in the wave soldering furnace be cleaned up? Here's a simple sharing.
According to the general rules of the industry, the tin in the wave soldering furnace is cleaned once a year, but this is not absolute. This is also determined according to the actual use of wave soldering, mainly from the following three points:
1. It is to see whether the product has a large amount of board.
2. Whether the temperature of the wave furnace is properly adjusted.
3. Whether the amount of tin added in the wave furnace is at the normal level.
Does the tin in the wave soldering furnace need to be cleaned up? Generally, we detect the tin in the wave soldering furnace mainly to see if the copper inside is beyond the standard. How to judge whether the tin in the tin furnace exceeds the standard? We can extract the tin in the tin furnace to come For spectral detection, if it is detected that the tin in the tin furnace exceeds 800PPM, we will suggest that customers take two solutions:
1. Cost-saving solution: add pure tin to dilute the copper content inside.
2. Complete solution: clean the tin in the tin furnace and add new tin into it.





