Aug 07, 2022 Leave a message

Principle and function of wave soldering spray system

The flux system is the first link to ensure the quality of soldering. Its main function is to apply flux evenly, remove the oxide layer on the soldering surface of the PCB and components, and prevent re-oxidation during the soldering process. The coating of the flux must be uniform, and try not to accumulate as much as possible, otherwise it will cause a short circuit or open circuit in the soldering.

Flux systems are available in a variety of ways, including spray, jet, and foam. At present, a spray-type flux system is generally used, and no-clean flux is used. This is because the solid content of the no-clean flux is very small, and the non-volatile and non-volatile content is only 1/5 to 1/20. Therefore, it is necessary to use a spray fluxing system to apply flux, and at the same time add an anti-oxidation system to the welding system to ensure that a uniform, fine and thin flux coating is obtained on the PCB, so that it will not be affected by the first wave. Scrub action and flux volatilization result in insufficient flux, leading to solder bridging and tipping.

There are two ways of spraying: one is to use ultrasonic waves to hit the flux to make the particles smaller, and then spray it onto the PCB. The second is to use a fine nozzle to spray the flux under a certain air pressure. This kind of spraying is uniform, small in particle size, easy to control, and the spray height/width can be adjusted automatically, which is the mainstream of future development.


Send Inquiry

whatsapp

teams

E-mail

Inquiry