Aug 16, 2022 Leave a message

How to set lead-free reflow soldering temperature?

The temperature profile of lead-free reflow soldering refers to the curve of the temperature at the test point on the surface mount device of the PCB as a function of time. Therefore, the lead-free reflow profile is an important factor in determining soldering defects. Setting the lead-free reflow temperature is a top priority in the reflow process. Here to share how to set lead-free reflow soldering temperature.

For lead-free solder paste, the temperature difference between components must be as small as possible. This can also be achieved by adjusting the reflow temperature. With traditional temperature profiles, although temperature differences between components as the plate develops peak temperatures are unavoidable, it can be reduced in several ways:

1. Extend the warm-up time. This greatly reduces the temperature difference between components before peak reflow temperatures are established. Most convection reflow ovens use this method. However, because the flux may evaporate too quickly by this method, it may cause poor wetting due to pin and pad oxidation.

2. Increase the preheating temperature. The traditional preheat temperature is generally 140~160°C, which may be increased to 170~190°C for lead-free solder. Increasing the preheat temperature reduces the required formation peak temperature, which in turn reduces the temperature difference between components (pads). However, if the flux cannot handle the higher temperature levels, it will evaporate again, resulting in poor wetting as the pad pins oxidize.

3. Trapezoidal temperature curve (extended peak temperature). Extending the peak temperature time of components with small thermal capacity will allow components and components with large thermal capacity to reach the required reflow temperature, avoiding overheating of smaller components. Using a trapezoidal temperature profile, as shown in Figure 6, a modern bonded reflow system can reduce the temperature difference between a 45mm BGA and the body of a small outline package (SOP) to 8°C.


Send Inquiry

whatsapp

teams

E-mail

Inquiry