Aug 15, 2022 Leave a message

How to prevent warpage of reflow soldering circuit boards?

Some boards are prone to bending and warping when reflow soldering. If serious, it may even lead to empty welding of parts, tombstones, etc. Due to various reasons, some electronic product circuit boards are prone to board bending and warpage after reflow soldering. Here is how to prevent warpage of reflow soldering circuit boards from occurring:

1. Reduce the effect of reflow soldering temperature on PCB circuit board stress

Since reflow soldering temperature is the main source of board stress, as long as the temperature of the reflow soldering furnace is lowered or the speed of heating and cooling of the board in the reflow soldering furnace is slowed down, the occurrence of board bending and board warping can be greatly reduced. However, other side effects may occur, such as solder shorts.

2. Use circuit boards with high Tg materials

Tg is the glass transition temperature, that is, the temperature at which the material changes from a glass state to a rubber state. The lower the Tg value of the material, the faster the board starts to soften after entering the reflow oven, and the time it takes to become a soft rubber state. It will also become longer, and the deformation of the board will of course be more serious. The use of a higher Tg sheet can increase its ability to withstand stress and deformation, but the price of the material is relatively high.

3. Increase the thickness of the circuit board

In order to achieve lighter and thinner thickness of many electronic products, the thickness of the board has been left at 1.0mm, 0.8mm, and even 0.6mm. Such a thickness should keep the board from deformation after passing through the reflow furnace, which is really a bit difficult. It is suggested that if there is no requirement for thinness and lightness, the thickness of the board should preferably be 1.6mm, which can greatly reduce the risk of board bending and deformation.

4. Reduce the size of the reflow soldering circuit board and reduce the number of panels

Since most of the reflow soldering uses a chain to drive the circuit board forward, the larger the circuit board will be dented and deformed in the reflow oven due to its own weight, so try to put the long side of the circuit board as the board side and put it on the back. On the chain of the soldering furnace, the concave deformation caused by the weight of the circuit board itself can be reduced, and the number of panels is also reduced for this reason. Sag deformation.

5. Use the oven tray fixture when reflowing the circuit board

If the above methods are difficult to do, the last thing is to use a reflow carrier/template to reduce the amount of deformation. The reason why the reflow carrier/template can reduce the bending of the plate is because whether it is thermal expansion or cold contraction, it is hoped that The tray can hold the board in place until the board's temperature drops below the Tg value and begins to harden again, and then maintains its original size.

If the single-layer tray cannot reduce the deformation of the circuit board, it is necessary to add a layer of cover to clamp the circuit board with the upper and lower trays, which can greatly reduce the deformation of the circuit board through the reflow oven. However, this oven tray is quite expensive, and you have to add labor to place and recycle the tray.

6. Use Router instead of V-Cut's sub-board

Since V-Cut will destroy the structural strength of the panel between the boards, try not to use the V-Cut sub-board, or reduce the depth of the V-Cut.


Send Inquiry

whatsapp

teams

E-mail

Inquiry