1.Preparation before mounting
According to the assembly details in the product process documents, collect the PCB and components and carefully check if the size, shape and color of the components themselves are consistent. Before starting the machine, conduct a safety check to ensure that the air pressure of the compressor air source meets the equipment requirements. Check and ensure that there are no obstructions around or within the moving range of the guide rails, assembly heads and suction nozzle library tray frames. The machine must be started in accordance with the equipment safety technical operation specifications.
2. Conduct a strict inspection after the first piece is mounted.
Check the specifications, orientation, polarity of the components on each board to see if they match the process documents; inspect for any damage or deformation of the components and pins; and verify if the deviation of the component mounting position from the pad exceeds the allowable range. Usually, the enterprise standards customized by the unit are used for judgment.
3. Inspection and Adjustment of First Article Test Paste Results
If there is a deviation in the placement position of components on the PCB, it can be calibrated by correcting the coordinate values of the PCB MARK point. Move the coordinates of the PCB MARK point in the direction of the component offset by an amount equal to the offset of the component placement position. The correct coordinates can also be repositioned through the camera. If the picking fails, it indicates that the picking height is not appropriate, the component thickness setting is incorrect, and the picking coordinates are incorrect. After checking, adjust and correct according to the actual value. Check if the suction nozzle is blocked, dirty, or if the end face is worn or cracked. It should be cleaned or replaced in a timely manner. A nozzle that is too large may cause air leakage, while a nozzle that is too small may result in insufficient suction. Choose the appropriate nozzle model based on the size and weight of the component. Check if there is any air leakage in the air circuit and promptly increase or clear the air pressure. Check if the image processing is correct. If it is not correct, the image may be frequently discarded and should be reshoot.
The final words
Before purchasing and using a surface mount machine, we should have a correct judgment of it. So, what factors make up the quality of a surface mount machine? How should we judge the quality of the surface mount machine?
One patch speed
Speed has always been an advantage of turret mounting machines, but with the development of technology, new mounting machines have been introduced, including several new frame mounting machines and modular mounting machines that install speed models. It has surpassed the new turret mounting machine. This can be seen from the performance parameter tables of different types of installation programs. But a more accurate algorithm is to use a stopwatch to calculate, which will eliminate some fraudulent data in the system and obtain the most accurate average value of patch energy efficiency.
Two patch precision
With the widespread application of microdevices and proximity devices, today's electronic products have put forward higher requirements for the placement accuracy of surface mount machines. A few years ago, the industry accepted precision standards for chip components and integrated circuit components. At present, there is a trend to narrow down the standard to chip components and integrated circuit components. At present, it is difficult for turret mounting machines to achieve an accuracy level of 0.05mm, and turret mounting machines can only achieve this level of accuracy. The advanced framework layout system can achieve an accuracy of 4 σ and 25 μ m. However, the machines that implement this function are not very fast.
Three patch range
The rotary surface mount machine is affected by the feeding method. It can only place components in tape or bulk packaging, but tubes and trays cannot be placed, even if its visual system can handle these components. The dense pitch components are usually packaged in trays, so the turntable installer is very weak in this indicator. Moreover, due to the limitations of the mechanical structure, there is basically no room for improvement





