The most important thing in the SMT reflow soldering process is the setting of the temperature curve of the reflow soldering furnace. There are many articles on the Internet about the temperature setting of the reflow soldering furnace, but many are not very useful. Here, I will share the correct setting method of the temperature curve of the SMT reflow soldering furnace.
The setting of the SMT reflow oven temperature is not achieved overnight, it is a process of repeated debugging. Among them, a series of temperature debugging is mainly carried out according to the selection of suitable temperature measurement points on the PCBA. The most scientific thing is to select the temperature measurement points that can reflect the highest, lowest, and key temperatures of BGA soldering. The selection of test points should be based on the center of the BGA; the center of the surface of the BGA package; the solder joints at the corners of the BGA; the largest core is the temperature curve test; the solder joints with the largest heat capacity; the solder joints with the smallest thermal fusion and other considerations .
At present, the temperature measurement mainly uses a special thermometer. This thermometer is currently domestic and imported. It is mainly based on the relatively small size of the temperature probe. First, it is connected to the computer, and then the temperature probe is attached to the The PCB light board is put into the furnace together during the reflow soldering process, and the temperature curve of the test can be displayed at the terminal.





