Because the temperature control of hot air reflow soldering directly affects the quality of reflow soldering, and because the soldering process window of reflow soldering is relatively small, we need to use the lateral temperature control method. The normal situation of the lateral temperature profile of hot air reflow soldering is affected by the following factors.
1. Hot air transfer process of hot air reflow soldering
When lead-free soldering, we need to pay attention to the loss of thermal efficiency during the transfer process. Especially like some components with large heat capacity, if the heat is not enough, it is easy to cause insufficient temperature.
2. Heat transfer method of hot air reflow soldering
Generally, we use the heating method of hot air micro-circulation, and blow the air outlet at the hole of the heating plate, so that the hot air flows in a small area. The design of the small circulation is due to the concentrated and clear direction of the flow of hot air. The heat transfer effect of such hot air heating is increased by about 15%, and the increase in the heat transfer effect will play a greater role in reducing the lateral temperature difference between devices with large and small heat capacity.
3. Control of chain speed of hot air reflow soldering
The control of the chain speed will affect the lateral temperature difference of the circuit board. Generally speaking, reducing the chain speed will give the device with large heat capacity more time to heat up, thereby reducing the lateral temperature difference. But after all, the setting of the furnace temperature curve depends on the requirements of the solder paste, so it is unrealistic to reduce the chain speed without limit in actual production.
4. Control of air speed and air volume of hot air reflow soldering
In the process of controlling the wind speed and air volume, we need to pay attention to the speed of the fan to minimize the exhaust air volume of the equipment, which is enough to affect the flow of hot air in the furnace. Another is the stability of the equipment. If the equipment is unstable, it is easy to jump out of the process window and cause cold welding or damage to the original device. Therefore, we should not forget to test the stability of the equipment when controlling the air speed and air volume of hot air reflow soldering.





