The influence of wave soldering process parameters on the quality of the soldering surface is complex and involves a wide range of technologies.
1. Control of preheating temperature
The role of preheating:
① Fully volatilize the solvent in the flux, so as not to affect the wetting of the printed board and the formation of solder joints when the printed board passes through the solder;
② Make the printed board reach a certain temperature before soldering to avoid warping due to thermal shock. According to our experience, the general preheating temperature is controlled at 180-200℃, and the preheating time is 1-3 minutes.
2. Inclination of wave soldering track
The influence of the track inclination on the welding effect is obvious, especially when welding high-density SMT devices. When the inclination angle is too small, bridging is more likely to occur, especially in soldering, the "shielded area" of the SMT device is more prone to bridging; while the inclination angle is too large, although it is conducive to the elimination of bridging, the solder joints eat too little tin, which is easy to produce virtual weld. The orbit inclination should be controlled between 5°-7°.
3. Wave height of wave soldering
The height of the wave crest will have some changes due to the passage of the soldering work time. It should be properly corrected during the soldering process to ensure the ideal height for the soldering wave crest height. The tinning depth is 1/2 - 1/3 of the PCB thickness. allow.
4. Wave soldering temperature
Welding temperature is an important process parameter that affects welding quality. When the soldering temperature is too low, the expansion rate and wetting performance of the solder deteriorate, so that the pads or component soldering ends cannot be sufficiently wetted, resulting in defects such as virtual soldering, sharpening, and bridging; when the soldering temperature is too high, It accelerates the oxidation of pads, component pins and solder, and is prone to virtual soldering. The soldering temperature should be controlled at 250+5℃.





